Topology:- Master can Ping to Node1 and Node2, but Node1 and Node2 Cannot Ping to Each Other.
Hello Everyone!!🖐
In this Blog I am going to create the Topology that Master can be Ping to Node1 and Node2 , but Node1 and Node2 cannot Ping to each other.
🔰For Configuring same Topology you need to following steps that are given below:-
STEP 1:-
Configure Master
STEP 1.1:-
IP of the Master
STEP 1.2:-
Change IP of Master
STEP 1.3:-
Check the IP Address of Master again
Now u Can see IP changed of Master
STEP 1.4:-
Create Route in Master
STEP 1.5:-
Check the Route in Master
Now u can see Route created
Finally , Master is configured✅
STEP 2:-
Configure Node1
STEP 2.1:-
IP of the Node1
STEP 2.2:-
Change IP of Node1
STEP 2.3:-
Check the IP Address of Node1again
Now u Can see IP changed of Node1
STEP 2.4:-
Create Route in Node1
STEP 2.5:-
Check the Route in Node1
Now u can see Route created
Finally , Node is configured✅
STEP 3:-
Configure Node2
STEP 3.1:-
IP of the Node2
STEP 3.2:-
Change IP of Node2
STEP 3.3:-
Check the IP Address of Node2 again
Now u Can see IP changed of Node2
STEP 3.4:-
Create Route in Node2
STEP 3.5:-
Check the Route in Node2
Now u can see Route created
Finally , Node2 is configured✅
STEP 4:-
Check by ping to each other
STEP 4.1:-
Master ping to Node1
Now u Can see Master is Pinging to Node1.✅
STEP 4.2:-
Master ping to Node2
Now u Can see Master is Pinging to Node2.✅
STEP 4.3:-
Node1 ping to Node2
Now u can see Node1 not Pinging to Node2.❌
STEP 4.4:-
Node2 ping to Node1
Now u can see Node2 not Pinging to Node1.❌
So, finally Topology is Ready!!✅
If you liked the above blog, please share it.
DM me on LinkedIn in case of suggestions/feedback/queries:
❗LinkedIN Link :-
ThankYou🙏